Connect the Oracle to the elektraDrive motor with a standard cat 5 cable.

Connect the power to the Oracle

Select “2:Slider” by moving the joystick up or down, or by hitting the red 2 button

Press enter to select

Orient the slider so that the eleltraDrive motor is to your left

Use the joystick to move the camera carriage to your desired start position. Note this position. For convenience you can use a piece of tape.

The Oracle has 3 memory banks indicated by the 1, 2 and 3 buttons.

Press and hold any numbered button for 5 seconds to clear that particular memory bank

The screen will say “erasing” and after a few moments it will display “move joystick to start record”

Move the joystick left and right to begin recording your camera movement

Max speed, damping, and deadband can all be adjusted during this time and will be recorded as will the timing.

All movement is recorded in real time and a seconds counter is displayed on the screen

Press the same memory bank button again to stop the recording

To play back your recorded movement click the button for the memory bank you recorded it under

The screen will prompt you to return the carriage to the start position noted previously.

Use the joystick to move the carriage to your start position

Press your memory bank button again to start playback